Steel structure design and shop drawings in Montenegro
The most expensive mistake in steel is a wrong dimension: a cut profile can’t be uncut. Our drawings are made so a welder reads them without calling — every part has a mark, length, cut angle and quantity.
For larger structures (halls, car-park canopies, mezzanines) we calculate to Eurocode 3 (MEST EN 1993) with wind and snow loads for your site. We also work for fabrication shops as a design partner: you build, we draw.
What we design in this area
- Canopy & carport designCarports, terrace and entrance canopies — wind calculation and shop drawings.from 150 €
- Steel hall designHalls, warehouses, workshops and farm buildings — frame, footings, drawings.from 800 €
- Steel stairs designIndoor and outdoor, spiral, single-stringer — comfortable, calculated stairs.from 120 €
- Fence and gate designFences, sliding and swing gates, pedestrian gates — with footings and motor prep.from 100 €
- Pergola designPergolas with louvres, fabric or plants — for terraces, gardens and pools.from 100 €
- Steel shop drawingsFor shops and welders: every part drawn, cutting list, DXF — fast.from 80 €
What you get
- Capacity calculation (Eurocode 3)
- General arrangement drawing
- Shop drawings for every part
- Material list and cutting plan
- Joints, bolts, welds
- DXF for plasma and laser
What we need from you
- Sketch or photo with dimensions
- Location (wind and snow)
- Preferred profiles or material, if any
Stages and timing
| # | Stages and timing | |
|---|---|---|
| 1 | Concept and dimensions | 1 day |
| 2 | Calculation | 1–3 days |
| 3 | GA and shop drawings | 1–5 days |
| 4 | Material list and DXF | 1 day |
Common mistakes and rejection reasons
- Profiles chosen by eye — too much or too little steel
- No wind check on the coast
- No lengths or cut angles on the drawing
- Anchors and footings undefined
FAQ
How much is a canopy drawing?
For a standard 1–2 car canopy it is affordable and takes 1–3 days. See the calculator for a ballpark.
Can I order drawings only?
Yes. We design; any welder or shop can fabricate.
Do you work for fabrication shops?
Yes — shop drawings and cutting lists to your brief, fast.
Do you supply DXF for plasma cutting?
Yes, plates and sheet parts come as cut-ready DXF.
Does a canopy need a permit?
It depends on size and location; we check the plan before designing.
Related services
Send us your task
A paper sketch, a photo or a picture from the internet — all fine. We reply within 1 hour on working days.